網站首頁 >> 常見問題 >> 磁粉探傷儀與磁粉探傷機對光照度的要求
磁粉探傷儀與磁粉探傷機對光照度的要求
磁粉探傷儀與磁粉探傷機雖然在體積大小、功能上有區別,但它們都對光照度有一定的要求甚至說標準。
由于磁粉檢測是通過對工件激磁,讓工件上的裂紋缺陷形成磁極吸附磁粉堆積在有裂紋缺陷工件的表面上形成磁痕,對磁痕顯示的觀察與評定,必須在可見的白光或紫外線光(黑光)下進行,也就是說觀察光源的發光強度、光照度等都將與磁粉檢測結果直接有關系。
由于人的眼睛視覺靈敏度會(huì )隨著光線強度變化而變化,因此人的眼睛在各種光強度下地顏色和對比度的識別能力會(huì )有變化。如果在白光下當光照度達到1000LX時,是眼睛觀察的最大明視覺。而在紫外光下,人的眼睛地380~400nm波長范圍內的光輻射變得很敏感,差不多是亮光下的靈敏度高30倍。如果在白光照度僅在1Lx左右時,紫外輻照度為1000uW/cm2時眼睛靈敏度將提高800倍對于熒光磁粉的磁痕更易觀察。
因此磁粉探傷儀或磁粉探傷機在進行磁粉檢測時,需根據所用磁粉的顏色,選擇合適的照度光源,如果用的是黑、紅磁粉可在白光下觀察,需注意白光照度需達到1000Lx,如用熒光磁粉,需注意白光照度需小于20Lx,紫外輻照度需超過1000uW/cm2。
轉載請注明轉載自:射陽宏旭探傷機制造有限公司http://www.coinbucks.top