網站首頁 >> 技術文檔 >> 探傷機進行磁粉探傷檢驗前的表面清理
探傷機進行磁粉探傷檢驗前的表面清理
作者:探傷機 發表時間:2013/3/21 8:51:24
探傷機對工件進行磁粉探傷檢驗前的表面清理是非常必要的,這項工序可以使檢測準確率大大提高并有效的保證工件安全。
1)清理表面由于加工后吸附在工件表面的鐵屑,必要時需要退磁。否則殘留的鐵屑會(huì )吸附磁粉形成假磁痕影響探傷檢測的準確性。
2)清理表面由于加工等原因殘留在工件表面的油脂灰塵等。使磁懸液噴灑到工件上均勻散布。
3)清理工件表面的鐵銹或氧化皮。防止通電磁化時對工件形成污染或灼傷工件。
4)對表面有涂漆或電鍍過的工件需特別注意,漆膜或鍍層須比較薄一般情況下厚度不得超過50μm。較厚的涂層會(huì )降低檢測靈敏度。如使用通電磁化時需注意將通電接觸部位以工藝認可的標準打磨使工件能夠直接通電,如非必須的情況下盡可能在工件進行涂裝之前檢測。
專業的射陽磁粉探傷機生產廠家就找射陽宏旭探傷機制造有限公司。
轉載請注明轉載自:射陽宏旭探傷機制造有限公司http://www.coinbucks.top